|Nominal voltage:||3.2 V|
|Operational voltage:||2.5 V - 3.65 V|
|The maximum charging voltage for initial charge:||3.65 V|
|Maximum discharge current:||2 C (max. 3 min)|
|Peak discharge current:||275 A (max. 30 sec)|
|Operating temperature (discharging):||-20 °C up to 60 °C|
|Operating temperature (charging):||-10 °C up to 50 °C|
|Energy density:||126 Wh/kg|
LiFePO4 is a very safe technology, with no spontaneous combustion, fire and explosion.The self discharge rate is very low. There is no memory effect – the cells can be recharged at any state of discharge.
|We suggest to use the cells in parallel to achieve higher capacity, i.e. 220 Ah (2 cells), 330 Ah (3 cells), 440 Ah (4 cells)|
GWL always tries to offer the best, our company-tested products. One of the successful outcomes that came through our precise testing and deep analysis is a new brand ELERIX. All products under the ELERIX brand have been based on a strict product and material quality selection, therefore the cells labeled by this brand can assure you the highest quality for a good price.
GWL would like to present you this fine brand where all its products excelled greatly in a material quality selection and in our heavy duty testing.
The following chart shows the discharging capacity test. Even the Discharging current 0.5 C, 1 C, 3 C , 4 C in voltage range 3.58 V - 2.5 V.
|Important: Always follow the guidelines in the USER MANUAL|
|Do you have technical question? Try our TECHNICAL SUPPORT SECTION.|
|Looking for more information and some valuable read? Try our BLOG.|
Cells are precharged from manufacturer to conservation charge (usually 30-50%).
The cells have to be charged with low current before the first use.
The first charge should not exceed 0.5 C - eg for 100 Ah cell is 50 A.
For initial charging of multiple cells, connect them in parallel and the charger outputs should be connected to both ends of the parallel rows of cells.
More information about charging ? F.A.Q section
We recommend to use chargers specially made for LiFePO4 cells. First charge and initial balancing of the whole pack is important step towards long lifetime.
Alternatively you can use regulated (Laboratory) Power supply as initial charge tool.
|Short description of how to proceed at our BLOG.|
|Nominal Voltage (V)||3,2|
|Max discharge current (A)||275|
|Optimal discharge current (A)||110|
|Max charging current (A)||110|
|Optimal charging current (A)||36,7|