Charger 48V/30A for LiFePO4 / LiFeYPO4 (58.8V) + BMS con.
Contact us:
phone: +420 277 007 550
email: export@gwl.eu
GWL/Power Lithium Battery Charger 48V/30A for LiFePO4
and Lipoly
(+ includes the management connector) – charging
voltage 58.80 Volts
Fully automatic advanced processor-controlled lithium battery charger for 48V nominal voltage. Designed to be used with 16 pcs of LiFePo4 cells or 14 pcs of Lipoly cells with charging up to 58.80V. This charger includes the connector for connection to the BMS system.
This GWL/Power charger is an industrial battery charger for lithium batteries, that allows charging the lithium cells in a safe and reliable way.
* Input AC 230V
* Over-voltage protection
* Protection anti short circuit and reverse polarity
* Timing protection for failure of charge
* Active cooling - fan
* BMS option - connector for connect to the BMS (Battery
Management System)
* Small size and low weight
Manual GWL-Power-POW48V30A-BLI_BMS-Spec.pdf
The specification of the BMS connector pins at GWL/Power blog.
Additional information about chargers at GWL/Power blog.
Application notes: Even though this charger is designed as a fully automatic charger, it is always recommended to operate this charger under continuous supervision and with additional monitoring of the charging parameters for the battery pack. It is necessary to make sure the cells of the battery pack will not be over-charged or misbalanced. We also suggest installing over temperature and fire protection alarms.
Connecting charger BMS with BMS123
Charger includes the management connector for BMS. BMS system should control the charging process. There are three states for BMS:
- Full charging 10 A
- Slow charging 2A
- Stop charging 0A
Charger is also fully automatic for stand alone using without BMS connection with advanced processor-controlled lithium battery charging process for 48V nominal voltage. This GWL/Power charger is an industrial battery charger for lithium batteries, that allows charging the lithium cells in a safe and reliable way.
For disconnect charger via BMS123:
connect black (GND) from charger to pin 2 on OUT board on charge relay contacts.connect Brown (ON/OFF) from charger to pin 3 on OUT board on charge relay contacts.
For reducing charge current via BMS123:
connect black (GND) from charger to pin 2 on OUT board on charge relay contacts.connect Blue (HIGH/LOW) from charger to pin 3 on OUT board on charge relay contacts.
| Weight (kg) | 4,3 |
| Height (mm) | 87 |
| Width (mm) | 150 |
| Depth (mm) | 300 |
| Nominal Voltage (V) | 48 |
| Max. voltage (V) | 58,8 |
| Charging current (A) | 30 |
Charger 48V/30A for LiFePO4 / LiFeYPO4 (58.8V) + BMS con.
Charger 48V/30A for LiFePO4 + BMS connector (AC 230V/10A, 16 cells, 4 batt) -...
345.00$
