The Victron EasySolar-II GX integrates a powerful MultiPlus-II inverter/charge and a SmartSolar MPPT solar charge controller. The unit is equipped with 2 x 16 character display. These elements come prewired, and preconfigured together inside a single unit. This greatly simplifies most installations, saving time and money.
Grid in-line topologyThe EasySolar-II GX will use excess PV power to charge the batteries or to feed power back into the grid and will discharge the battery or use power from the grid to supplement a shortage of PV power. In case of a power outage, the EasySolar-II GX will disconnect the grid and continue to supply the loads. Loads that should shut down when AC input power is not available can be connected to a second output (not shown). These loads will be taken into account by the PowerControl and PowerAssist function in order to limit AC input current to a safe value.
Grid parallel topologyThe EasySolar-II GX will use data from the external AC current sensor (must be ordered separately) or power meter to optimise self-consumption and, if required, to prevent grid feed. In case of a power outage, the EasySolar-II GX will continue to supply the critical loads.
Display and Wi-FiThe display reads battery, inverter and solar charge controller parameters. The same parameters can be accessed with a smartphone or other Wi-Fi enabled device. In addition, Wi-Fi can be used to set up the system and to change settings.
Solar charge controllerThe DC output of the SmartSolar MPPT is parallel wired with the DC connection of the MultiPlus-II inverter/charger. The on/off mechanism of the MultiPlus-II also controls the SmartSolar MPPT.
|The complet datasheet with technical specification can be found in Documets for download.|
|Input voltage (V)||38-66|
|Min. operating temperature (°C)||-20|
|Max. operating temperature (°C)||+45|