Blog - Chargers and charging

New product - Socket for Electric Vehicles according to SAE...

New product - Socket for Electric Vehicles according to SAE J1772-2009 including the cable with protection tube (1m, 16A).

The J1772-2009 socket is designed for single phase electrical systems with 120 V or 240 V such as those used in North America, Japan and is still supported by some European car manufacturers. (Renault, Peugeot, Citroen etc.) The connector is needed to use for system with 1 kHz square wave at +/- 12 volts generated by the Ele

The single cells charges: 3.6V 5 Amp and 3.6V 18 Amp

The single cells charges: 3.6V 5 Amp and 3.6V 18 Amp

Proper charging of the LiFePO4 cells is a must. The single cell chargers allow charging of single LFP cells directly. GWL offers two models: . These chargers should be used to make the initial charging of the LF

IEC 60309  - 3 phase AC sockets

IEC 60309 - 3 phase AC sockets

The industrial sockets for AC powering – . The typical household rating is 16Amp and 32Amp. With „C and D grade” of circuit-breakers, it may be possible to drain some 18 and 34 Amps from these sockets. It is also

Automated guided vehicle

How to make AGV (automated guided vehicle) with automatic charging of LiFePO4 cells?

----------------------------------------------------------

We must design battery pack with protection (, ) and .

Battery pack

The operating voltage of the AGV is 24V. To obtain a nominal voltage of 24V we will need 8 cells. We recommend u

The EVSE - the setting of the charging current

The EVSE - the setting of the charging current

You can set the charging between the 6 Amp and more. Please note that the maximal charging power depends on the power rating of the electric car charger. Example: If you have a 3.3 kW on-board charger, the maximum power will be 3.3 KW (so

EVSE connection wiring diagram

EVSE connection wiring diagram

Check the wiring diagram for the EVSE board. Do not forget to connect the GND to the PE wire.

See more details here:/

The EVSE projects details -

Make your own charging cable for your EV!

Make your own charging cable for your EV!

Check our new product - ! Now you can directly charge you vehicle (, Citroen Berlingo Electrique, Opel Ampera, Renault Fluence, Mitsubishi Miev, Mia Electric, Citroen C-Zero, Peugeot iOn

The New Range of Mennekes type IEC62196-2 EVCharge...

The New Range of Mennekes type IEC62196-2 EVCharge Products

New products for electric car users: benefit from the charging infrastructure using the Mennekes type IEC62196-2 connectors with cabling. We offer a complete product range for the charging cabling: Plug-In Head, Extension Cable M+F, Car Socket Inlet Panel. C

Charging with up to 16 Amp – check your AC socket quality...

Charging with up to 16 Amp – check your AC socket quality first! For 16 Amp charging currents we recommend to connect the open end of the charging cable directly to an electrical distribution board. It is also recommended to use CEE Caravan plug or the 3-phase 16/32A 400V 5pin plug. In case of using common Schuko 16A home plug there is hi

FAQ: Is your charging cable compliant with EU norms?

FAQ: Is your charging cable compliant with EU norms?

The charging cable is a set of components for further installation. The cable itself, the connector and the EVSE board are sub parts that were manufactured according to all relevant standards. In this view it is compliant with all st