GWL’s customer operating the electric bus with a LFP battery pack has involuntary performed areal EV Bus crash test. The bus driver in Northern Bohemia was passing the railway, while the local train was approaching. Unfortunately, the bus driver did not let the train pass first andthe
The photo of the components that allow the expansion (or extension) of the service connector for the.
NOTE: If the servic
Check the overview of the useful accessories to make it easier for you to use and.
Ready to go?
These photos show the magnetic service connector for the.
The opposite part of the connector is supplied withthe packing of EX-L12V100R. Optionally you can purchase another connector separately.
To make the servi
To connect the ELERIX EX-S5 with Victron Cerbo GX, there is a need for a special cable.
This cable can be purchased on-line. You can also study the support information and get more details about the CAN connectors pin outs and how to make this cable.
Check more links:
is designed to be used a service connector for a 5-pin wiring. This means it can be used to transfer 4 signals and one common ground.
For DC application this service connector is purposedto be used for a quick connection to 12V battery banks o
Q: I wish to check the capacity of the cell in my battery pack. How to do that?
Answer:Originally there were not any suitable products in the market that would allow the quick and easy testing of individual cells or the packs in a battery. There were only some costly and professiona
Check the offer for the
An easy solution for a 12V lead-acid battery replacement.
Check additional accessories:
… more to come
This diagram shows the connection ofthe AMETEK Latching Relay with CPM Board.
The relay is controlled by theCPM Board contacts. However, because the AMETEK Latching relay needs a high current rated power supply for the coils, the latching relay itself needs to be connectedby means
This diagram shows the connection ofthe AMETEK Latching Relay with BMS123.
The relay is controlled bythe BMS123 Load Relay NC contact. The auxiliary relay is powered by the DC main voltage and it will create the impulse signal for the latching relay to disconnect.
Since the main